All guides

England versionOther versions: France (in French) · Belgium (in French) · Switzerland (in French)

Air conditioning and heat pumps

Do you need permission to install air conditioning?

Check the unit, the building and your right to alter it before booking installation.

The answer in 2 lines. In England, a portable appliance used indoors without building alterations will not normally need planning permission. A fixed system needs closer checking. A qualifying air source heat pump that heats and cools may fall within permitted development, subject to all applicable conditions. Cooling-only equipment has no equivalent blanket exemption, although work that does not materially affect the building's external appearance may not require planning permission. Separately, check landlord or freeholder consent, heritage restrictions, noise and building regulations.

The first steps

  1. Ask the installer to identify whether the proposed system is cooling-only or an air source heat pump providing heating and cooling.
  2. Enter your postcode in Find your local council. Contact planning with photographs, the unit's dimensions and its proposed location.
  3. If you rent, request written landlord consent before fixed alterations. If you own a leasehold flat, read the alteration clauses and identify whose written approval is required.

Stop: danger

  • Pause installation if consent is unresolved: an installer's assurance does not replace a required planning decision or permission under your lease.
  • Pause if the proposed location changes: moving the outdoor unit can change the noise assessment, visual impact and permissions needed.

Which planning route applies?

  • Portable appliance with no building work: ordinarily there is no planning application. Cutting a permanent opening or installing external equipment changes the question.
  • Heating-and-cooling air source heat pump: permitted development may apply if every relevant condition is met. The rules cover matters including equipment, siting, noise and protected locations.
  • Cooling-only fixed equipment: do not assume the heat-pump permission applies. Whether the work constitutes development requiring permission depends on its effect on the building, including its external appearance.

The Government explained this distinction in its July 2026 parliamentary answer. Use it to frame your enquiry to planning, rather than assuming that all small units are exempt.

Give planning a complete proposal

Supply the model specification, whether it heats as well as cools, outdoor dimensions, wall or ground mounting, pipe routes and photographs showing nearby windows. Ask the installer for the applicable planning-standard noise assessment and an explanation of how the installation meets the conditions.

Ask the council whether local restrictions or the building's status affect the proposal, and what formal confirmation or application is appropriate. Keep its response with the quote. A general discussion about air conditioning is less useful than advice addressing the actual equipment and location.

The England permitted-development legislation contains the domestic air source heat-pump provisions in Schedule 2, Part 14, Class G. Ask planning to identify the conditions relevant to your property.

What not to do

  • Assuming that planning permission also gives you permission to alter a shared wall or roof.
  • Paying a non-refundable installation deposit before the required consents are settled.
  • Choosing a location beside a neighbour's bedroom window without assessing noise and vibration.
  • Treating rules for England as permission to carry out the same work elsewhere in the UK.

Leasehold flats and rented homes

Your lease may restrict alterations, external appearance or use of shared parts. Identify who controls the wall, roof or balcony before proposing a unit there. If consent is required, obtain it in the form required by the lease before work starts.

Read the Leasehold Advisory Service guidance on alterations alongside your lease. Send whoever grants consent the specification, drawings, pipe route, noise information and arrangements for future maintenance.

If you rent, send the same proposal to your landlord and check the tenancy agreement. Ask who will own and maintain the equipment and what must happen when you leave. Your landlord may also need permission from a superior landlord or freeholder.

Heritage, noise and installation standards

For a listed building, alterations affecting its special character can need listed building consent separately from planning permission. Read Historic England's consent guidance, then ask the council about the proposed fixings and pipework before starting.

Planning compliance does not settle every noise issue. GOV.UK's statutory nuisance guidance explains when councils must investigate. Use the council finder above to contact environmental health if a noise problem develops.

Ask the installer how electrical work will comply with building regulations. For equipment containing fluorinated refrigerants, check the applicable qualifications against GOV.UK's F-gas qualification guidance and request evidence before commissioning the work.

Good to know

  • These planning rules concern England. Wales, Scotland and Northern Ireland have different planning regimes.
  • Keep the approved specification, permissions, installation documents and maintenance instructions together; later alterations may need fresh checks.

For example, a leaseholder proposes a reversible system with an outdoor unit on a shared external wall. She obtains the specification and noise assessment, checks the planning position and requests the consent required by her lease. When the proposed location changes, she gets the revised position checked before installation.

A made-up story, for illustration.

Bobby

Read more guides

Bobby publishes free practical guides written for England: English laws, numbers and organizations. In England, Bobby answers your questions; it does not put you in touch with professionals.

All guides: England

Sources, verification, confidence

Verified on 7 November 2026, for England. Confidence: high for the distinction between cooling-only equipment and qualifying heating-and-cooling heat pumps, and for the separate leasehold, heritage and refrigerant requirements; medium for whether an individual installation needs planning permission, which depends on the property, equipment, siting and applicable restrictions. No universal fee or decision deadline is asserted.

Related guides

Also worth reading